This is an upgrade kit for the G9 Classic Mini Enail by Greenlightvapes which replaces the stock banger and heating coil with an Elev8R quartz heater and a coil that is specially made to fit the Elev8R. With this kit you can use your G9 Classic Mini Enail to convection vape dry herb!
The kit is assembled by screwing the Elev8R quartz heater into the coil from the bottom up. A small nub towards the top of the Elev8R will slide nicely in between the twisted sections of the coil. When installed properly the nub will prevent the coil from slipping off of the Elev8R. The bottom of the Elev8R has a short 19mm male joint that will attach to the 19mm female joint at the top of the Elev8R Rig Adapter. The bottom of the Elev8R Rig Adapter has a 14mm male joint which allows the entire kit to be attached to your rig of choice.
If you need a replacement coil for this kit you can purchase a Replacement Kevlar Heat Coil for Elev8r E-Heater Rig Kit.
- Customers in North America and Japan should choose the 110V option.
- Customers in Europe and Australia should choose the 220V option.
- Consult with your power provider if you are unsure which voltage option to choose.
Note: All ELEV8R Quartz Heaters come standard with an accent dot nipple attached on the outside, near the top of the heater.
Kit Includes:
- 1x Elev8R E-Nail 16mm Heater Coil
- 1x ELEV8R Quartz Heater with a 15.8mm Screen (Blue Pack) installed.
- 1x ELEV8R Sick Clip
- 1x 16.9mm Flavor Disc
- 1x Marble Pick
- 1x 14mm Elev8R Rig Adapter with a 20.8mm Screen (Yellow Pack) installed.
- 1x Pack of 20.8mm Screens (Yellow Pack)
- 1x 19mm Ground Glass Stand
5-Pin Coil Jack ONLY FITS G9 CLASSIC MINI ENAIL PID CONTROLLER!
1 Review
-
ELEV8R E-HEATER RIG KIT
Very nice kit mine came with a new heater stand it has a bigger base so it shouldn't fall over as easy as the older one did Thanks Elev8
Elev8r Enail Rig Kit Upgrade For G9 Classic Mini Enail (PID NOT INCLUDED)
By continuing you accept the Terms & Conditions and verify you are 21+ years old.